Abstract
We analyzed the dry etching of perovskite oxides using argon-based inductively coupled plasmas (ICP) for photonics applications. Various chamber conditions and their effects on etching rates have been demonstrated based on Z-cut lithium niobate (LN). The measured results are predictable and repeatable and can be applied to other perovskite oxides, such as X-cut LN and barium titanium oxide (BTO). The surface roughness is better for both etched LN and BTO compared with their as-deposited counterparts as confirmed by atomic force microscopy (AFM). Both the energy-dispersive X-ray spectroscopy (EDS) and X-ray photoelectron spectroscopy (XPS) methods have been used for surface chemical component comparisons, qualitative and quantitative, and no obvious surface state changes are observed according to the measured results. An optical waveguide fabricated with the optimized argon-based ICP etching was measured to have -3.7 dB/cm loss near 1550 nm wavelength for Z-cut LN, which validates this kind of method for perovskite oxides etching in photonics applications.