Abstract
This study prepared fresh ferric hydroxide (in-situ FeOxHy) by the enhanced hydrolysis of Fe(3+) ions, and investigates its adsorptive behaviors toward Sb(III) and Sb(V) through laboratory and pilot-scale studies. A contact time of 120-min was enough to achieve adsorption equilibrium for Sb(III) and Sb(V) on the in-situ FeOxHy, and the Elovich model was best to describe the adsorption kinetics of Sb(III) and Sb(V). The Freundlich model was better than Langmuir model to describe the adsorption of Sb(III) and Sb(V) on the in-situ FeOxHy, and the maximum adsorption capacity of Sb(III) and Sb(V) was determined to be 12.77 and 10.21 mmol/g the in-situ FeOxHy as Fe, respectively. Adsorption of Sb(V) decreased whereas that of Sb(III) increased with elevated pH over pH 3-10, owing to the different electrical properties of Sb(III) and Sb(V). Adsorption of Sb(III) and Sb(V) was slightly affected by ionic strength, and thus indicated the formation of inner sphere complexes between Sb and the adsorbent. Sulfate and carbonate showed little effect on the adsorption of Sb(III) and Sb(V). Phosphate significantly inhibited the adsorption of Sb(V), whereas slightly effected that of Sb(III) due to its similar chemical structure to Sb(V). Pilot-scale continuous experiment indicated the feasibility of using in-situ FeOxHy to remove Sb(V), and equilibrium adsorption capacity at the equilibrium Sb(V) concentration of 10 μg/L was determined to be 0.11, 0.07, 0.07, 0.11, and 0.12 mg/g the in-situ FeOxHy as Fe at equilibrium pH of 7.5-7.7, 6.9-7.0, 6.3-6.6, 5.9-6.4, and 5.2-5.9, respectively.