Abstract
Subfossil wood is a valuable and rare material often used for production of expensive furniture and decorative artistic items of unique beauty. Its mechanical and tribological properties are still being studied and are considered specific due to the particular conditions of its long-lasting formation in aqueous sediment sludge. Various elements that have been impregnated into the wood tissue over many years make the machining and grinding of this type of wood rather difficult compared to normal recent wood. The main objective of this study was to determine the influence of the abrasive grain size of sandpaper on the abrasion volume loss of recent and two subfossil oak samples in three characteristic sections (cross, radial, and tangential). The results showed that the average size of abrasive grains and the orientation of the wood structure have an influence on the abrasion volume loss of all three samples. The phenomenon of the critical size of abrasive grains was observed in all samples and on all sections. As the size of abrasive grains increased to the critical size, the abrasive volume loss of the sample increased simultaneously. The lowest abrasion volume loss was observed on recent oak. In all samples, the lowest volume loss was measured on the cross sections, and the tangential and radial sections had mutually equal values. It was also found that the increase in the size of abrasive grains to a critical value resulted in the increasing value of the absolute difference between the abrasion volume loss of the cross, radial, and tangential section samples, while the relative relations between the abrasive volume loss values of three different sections (C/R, C/T, R/T) within the same grit of sandpaper remained quite similar.