Abstract
We fabricated a microfluidic chip (osteoblast [OB]-osteoclast [OC] chip) that could regulate the mixture amounts of OB and OC supernatants to investigate the effect of different supernatant distributions on osteogenesis or osteoclastogenesis. Computer-aided design was used to produce an OB-OC chip from polydimethylsiloxane. A pressure controller was assembled and different blends of OB and OC supernatants were correctly determined. OB and OC supernatants were placed on the upper panels of the OB-OC chip after differentiation for an in vitro evaluation. We then tested the changes in osteogenesis using MC3T3-E1 cells in the middle chambers. We observed that a 75:25 distribution of OB and OC supernatants was the most potent in osteogenesis. We then primed the osteogenic differentiation of MC3T3-E1 cells using an OB-OC mixed supernatant or an OB supernatant alone (supernatant ratios of 75:25 or 100:0, respectively). These cells were placed on the calvarial defect sites of rats. Microcomputed tomography and histological analyses determined a significantly higher bone formation in the group exposed to the OB-OC supernatant at a ratio of 75:25. In this study, we demonstrate the applicability of an OB-OC chip to evaluate the effect of different supernatant distributions of OB and OC. We observed that the highest bone-forming potential was in MC3T3-E1 cells treated with conditioned media, specifically the OB-OC supernatant at a ratio of 75:25.