Abstract
Per- and polyfluoroalkyl substances (PFAS) are refractory anthropogenic chemicals and current treatment processes at municipal water resource recovery facilities (WRRFs) cannot efficiently degrade them, hence, these chemicals cycle through the environment. Certain PFAS can be concentrated in biosolids from WRRFs and are commonly land applied for beneficial reuse. Given recent advances in measurement of PFAS, documentation of the range of concentrations in pre-stabilized sludge and stabilized biosolids is critical to evaluating treatment best practices and assessing potential human health and ecological risks. In this study, pre-stabilized sludge and post-stabilized biosolids samples were collected from 12 major WRRFs across the United States. PFAS were analyzed using Environmental Protection Agency (EPA) Method SW846-3500C/537.1, and Draft EPA Method 1633, by one commercial laboratory and two university research laboratories, respectively. Results comparison among laboratories demonstrated statistical differences in PFAS concentrations among split samples. For example, 5:3 FTCA (fluorotelomer carboxylic acid) concentrations in post-stabilized sludge at Lab 1 were measured at 21 ng/g (dry), while they were detected at 151 ng/g (dry) in Lab 3. Further, higher PFAS concentrations were observed in post-stabilized biosolids compared to pre-stabilized sludges, regardless of the laboratory or analysis method, even when solids destruction through solids stabilization was considered. Further research is required to refine methods for analyses of PFAS in sludge and biosolids samples from WRRFs prior to being used for development of regulatory actions as well as understanding how various treatment protocols could impact concentrations of PFAS in land-applied biosolids.