Abstract
Due to extensive industrialization and ongoing fossil fuel consumption, CO(2) emissions have significantly contributed to climate change and rising greenhouse gas levels. The collection and storage of CO(2) in subsurface geological formations have been proposed as a feasible alternative. The well-documented In Salah storage site is the subject of the chosen case study. For the numerical analysis, a two-dimensional finite element simulation of fault reactivation processes was conducted in the context of the CO(2) storage. The goal of this research is to conduct a mechanistic numerical analysis of a typical CO(2) storage condition. The selected analysis domain is 4 km (width) × 2 km (depth) and includes all important domains and formations (overburden, main caprock, lower caprock, and underburden) of the In Salah site. The simulation results indicate that the influence of fault reactivation under 32 MPa of base injection pressure results in peak vertical deformation of 0.044 m in the caprock and a vertical displacement magnitude of 0.015-0.020 m at the surface level (Z = 0 m). The derived vertical deformation findings at the surface level are in agreement with the data obtained from the in situ InSAR monitoring system in 2009. The effects of the changes in the fault dip angle, key caprock mechanical parameters, and in situ stress ratio on the displacement profile are evaluated within the parametric study. In comparison to the benchmark numerical run, the scenario ratio of k = 0.5 led to a significant reduction in the displacement. The simulation in which the fault dip angle was 30° produced a more pessimistic result with a larger displacement field. This could be an indication of heightened fault reactivation risks associated with low-angle faults in storage sites with strong horizontal stress regimes due to the combined effect of increased shear stress and reduced inherent frictional resistance on the fault plane. Considering that a vertical fault dip angle (90°) and an additional three 20 m long vertical fractures above the reservoir produced similar vertical displacement observed with the fault dipping at a 60° angle, this indicated that the vertical faults in the vicinity of the storage site pose limited safety risks to the integrity of the sealing rock.