Abstract
The objective of this study was to explore the effect of the assembly sequences of wall materials on the structure and properties of Antarctic krill peptide (AKP)-loaded ovalbumin (OVA)-chitosan (CS) nanoparticles (NPs). Two AKP-loaded NPs (CS/OVA-AKP and OVA/CS-AKP) were prepared by changing the sequences of OVA and CS. The results confirmed that CS/OVA-AKP had a smaller particle size (291 nm vs. 320 nm), lower polydispersity index (0.233 vs. 0.282), higher absolute zeta potential (34.4 mV vs. 32.1 mV), and higher encapsulation efficiency (81.6% vs. 75.4%) than OVA/CS-AKP. X-ray diffraction analysis confirmed that AKP was encapsulated in an amorphous state within the NPs. Fourier transform infrared spectroscopy and three-dimensional (3D) fluorescence spectroscopy revealed that electrostatic interactions, hydrogen bonding, and hydrophobic interactions were the primary driving forces for nanoparticle formation, with CS/OVA-AKP demonstrating a stronger OVA fluorescence quenching effect. Compared with OVA/CS-AKP, CS/OVA-AKP exhibited better redispersibility, and CS/OVA-AKP showed greater stability under various environmental factors (thermal treatment, salt concentration, pH, and storage time). During simulated gastrointestinal digestion, CS/OVA-AKP effectively protected AKP from gastric degradation and showed a higher AKP release rate in simulated intestinal fluid (61.1%) than OVA/CS-AKP (53.0%). The release followed the Korsmeyer-Peppas model, with OVA/CS-AKP exhibiting non-Fickian diffusion (n = 0.7500), and CS/OVA-AKP approached Case II transport (n = 0.9889), indicating erosion-controlled release behavior. CS/OVA-AKP also demonstrated higher hypoglycemic activity, with inhibition rates of 41.1%, 37.5%, and 36.1% for α-glucosidase, α-amylase, and DPP-IV, respectively. These findings underscore the important influence of wall-material assembly sequences on the structure and properties of AKP-loaded NPs, offering valuable insights for the development of bioactive peptide delivery systems.