Abstract
Wireless local area networks (WLANs) have recently evolved into technologies featuring extremely high throughput and ultra-high reliability. As WLANs are predominantly utilized in Internet of Things (IoT) and Wi-Fi-enabled sensor applications powered by coin cell batteries, these high-efficiency, high-performance technologies often cause significant battery depletion. The introduction of the trigger frame-based uplink transmission method, designed to enhance network throughput, lacks adequate security measures, enabling attackers to manipulate trigger frames. Devices receiving such frames must respond immediately; however, if a device receives a fake trigger frame, it fails to enter sleep mode, continuously sending response signals and thereby increasing power consumption. This problem is specifically acute in next-generation devices that support multi-link operation (MLO), capable of simultaneous transmission and reception across multiple links, rendering them more susceptible to battery draining attacks than conventional single-link devices. To address this, this paper introduces a Secure Triggering Frame-Based Dynamic Power Saving Mechanism (STF-DPSM) specifically designed for multi-link environments. Experimental results indicate that even in a multi-link environment with only two links, the STF-DPSM improves energy efficiency by an average of approximately 55.69% over conventional methods and reduces delay times by an average of approximately 44.7% compared with methods that consistently utilize encryption/decryption and integrity checks.