Aflatoxin M1 Concentrations, Adulterants, Microbial Loads, and Physicochemical Properties of Raw Milk Collected From Nekemte City, Ethiopia.

阅读:7
作者:Nasir Leila, Gemede Habtamu Fekadu
Milk is an essential part of the human diet and is a nutrient-rich food that improves nutrition and food security. The aim of this study was to determine the presence and concentration of aflatoxin M1 (AFM1), adulterants, microbial loads, and physicochemical properties of raw cow's milk (CM) in Nekemte City, Ethiopia. A total of 12 samples of fresh CM were purposefully collected from four kebeles in the city (Bake Jama, Burka Jato, Cheleleki, and Bakanisa Kese) based on the potential of each milk production and distributor site. The AFM1 concentration was determined by high-performance liquid chromatography (HPLC) with a Sigma-Aldrich standard (St. Louis, MO, USA). The concentrations of AFM1 in Bake Jama, Burka Jato, Cheleleki, and Bakanisa Kese were found to be 0.01-0.03 g/L, 0.31-0.35 g/L, 0.19-0.21 g/L, and 0.04-0.07 g/L, respectively. The concentrations of AFM1 in the present study varied significantly (p < 0.05) and ranged from 0.01 g/L to 0.35 g/L. These results show that of the 12 samples tested, all were positive for AFM1 and contaminated to varying degrees. The results of this study also revealed that the concentration of AFM1 in 7 (58%) of the 12 milk samples was above the European Union's (EU) maximum tolerance limit (0.05 g/L). The present study also revealed that of the investigated adulterants, only the addition of water had positive effects on three milk samples, while the remaining adulterants were not detected in any of the milk samples. The total bacterial count (TBC) and total coliform count (TCC) were significantly (p < 0.05) different and ranged from 5.53 to 6.82 log(10)cfumL(-1) and from 4.21 to 4.74 log(10)cfumL(-1), respectively. The physicochemical properties of the milk samples in the present study were significantly (p < 0.05) different and ranged from 2.8% to 5.75% fat, 7.03% to 9.75% solid-not-fat (SNF), 2.35% to 3.61% protein, 3.33% to 5.15% lactose, 11.54% to 13.69% total solid, 0.16% to 0.18% titratable acid, 26.7 to 32.1°C, 6.35 to 6.55 pH, and 1.027 to 1.030 specific gravity. The physicochemical parameters of the raw milk in the study area met the required quality standards. Hence, further studies are required to determine the extent of the problem and the factors associated with high levels of AFM1 in raw milk in the study areas, including the detection of aflatoxin B1 (AFB1) in animal feed.

特别声明

1、本文转载旨在传播信息,不代表本网站观点,亦不对其内容的真实性承担责任。

2、其他媒体、网站或个人若从本网站转载使用,必须保留本网站注明的“来源”,并自行承担包括版权在内的相关法律责任。

3、如作者不希望本文被转载,或需洽谈转载稿费等事宜,请及时与本网站联系。

4、此外,如需投稿,也可通过邮箱info@biocloudy.com与我们取得联系。